2013年12月8日星期日

Hydraulic press Steps


Hydraulic press Step one : First of all aids should be ready and containers , check and adjust the belt tightness . Then start the motor , the machine empty running around 15min, check the speed of the pressing screw shaft. Average speed should be around 33dmin. Do you want to pay attention to when idling gear box gear meshing and sound normal, wire stripper bearings and motor parts properly. When press idling , the motor current should be about 3A. If the current is too high , you should immediately stop checks, adjustments and then boot.
Hydraulic press Step 2: After the normal load , about 50kg ready rapeseed or soy , ready to put into the hopper . Note: When you start squeezing feed not too fast, otherwise the sudden increase in pressure within the bore virgin , virgin not turn the screw shaft , causing blockage virgin bore , even to squeeze cage rupture, a major accident . So at the beginning of the compression , the feed should be evenly slowly into the hopper , machine for pellet be run together . So repeatedly , sustained more than 3 ~ 4h , so press the temperature gradually increased, and even take smoke . At the start of the press virgin bore low temperature, can be slowly twist the handle on the withered section stud , increase the thickness of the cake , while improving moisture billet into juice , to be squeezed bore temperature. Rose to about 90 ℃, the normal operation of the press , the cake thickness can be adjusted to 1.5 ~ 2.5mm, and tighten the nut tightened.

没有评论:

发表评论