2015年2月26日星期四

machine for pellets maintenance

1, regular inspection parts, once a month, check the worm, worm, lubricating block bolts, bearings and other moving parts are rotating flexible and wear, find defects should be repaired, not reluctant to use.
2, the machine should be placed on a clean dry machine for pellets, not in the atmosphere contains acids and other corrosive gases on the body circulation places.
3, the machine after use or stopped, remove the rotating drum for cleaning and clearing brush remaining powder will fight, and then properly installed, ready to work for the next use.
4, when the drum ran around in the work place, please adjust the front bearing on the M10 screws Death to the appropriate location. If the gear shaft runout occurs, please adjust the bearing frame behind the M10 screws to the proper position, adjust the gap to the pelleting machine noise does not occur, the hand turn pulleys, elastic appropriate appropriate, are too tight or too loose can make the machine may be damaged .
5, such as disabling a long time, you must wipe clean the machine body, parts of the glossy coated rust oil, cover with a cloth Punta good.

没有评论:

发表评论