pellet equipment institutions made instructions

1, the main body: body as a separate rectangular cylinder, closed its bearing on the device connected with the powder hopper, powder hopper toward the outside of the body, under which the chassis is equipped with V-shaped, with wide, flat ground, so be fitted can be arbitrarily placed indoors.
2, particle manufacturing equipment: rotary drum set pellet mill machine lying underneath the front and rear bearing support, it is through the rack gear for inverted rotation, the front end face of the bearing cap is movable assembly and disassembly, as long as spin under a wing nut, bearing cap and rotating drum to be pulled out, placed at both ends of the drum is formed with a convex side ring embedded in the bearing chamber, so that the oil may penetrate the powder adhesion promoter and will not be clogged.
3, gear box: The worm gear, ratio to 1:12, can be stored inside the oil, gear lubrication to ensure a good and no noise, boxes can be observed on the sight glass to observe the functioning and oil reserves, the outer end of the worm gear, with an eccentric shaft, driven rack reciprocated.
4, screen clip tube: both sides of the rotary drum unit with a steel pipe manufacturing, in the middle there is a long open slot, screen at both ends into the trench, flower-shaped hand wheel pelletizing screen wrapped in a cylindrical rotating drum, and There handwheel gear shore, elastic can be adjusted.
5, the motor frame: a prison with the screw bolt, the motor mounted on an iron plate, when turning the screw bolt, the motor up and down movement for adjusting the belt.

machine for pellets maintenance

1, regular inspection parts, once a month, check the worm, worm, lubricating block bolts, bearings and other moving parts are rotating flexible and wear, find defects should be repaired, not reluctant to use.
2, the machine should be placed on a clean dry machine for pellets, not in the atmosphere contains acids and other corrosive gases on the body circulation places.
3, the machine after use or stopped, remove the rotating drum for cleaning and clearing brush remaining powder will fight, and then properly installed, ready to work for the next use.
4, when the drum ran around in the work place, please adjust the front bearing on the M10 screws Death to the appropriate location. If the gear shaft runout occurs, please adjust the bearing frame behind the M10 screws to the proper position, adjust the gap to the pelleting machine noise does not occur, the hand turn pulleys, elastic appropriate appropriate, are too tight or too loose can make the machine may be damaged .
5, such as disabling a long time, you must wipe clean the machine body, parts of the glossy coated rust oil, cover with a cloth Punta good.