The juice squeezed from the bore axis drawn

Oil press down immediately after moving the handle, squeeze the juice from the axis of the bore draw, remove the protective cap, round nuts, bearings and adjusting bolt. Iron rod with a diameter of 16 hole insert locknut counterclockwise rotation, remove the lock nut, each section can be removed pressing screw. Removing bad as pressing screw,  Oil machine  before removing the wood fire.
Pressing screw mounting: the virgin oil press screw erect, narrow end up, and then the slag Shaotou and pressing screw followed by Arranging the order 7,6,5,4,3,2,1 Mounted on the shaft and then loaded asbestos gasket, and then tighten the nut to prevent the infiltration of diesel spiral, the impact of the demolition of the pressing screw, and  oil expeller  bearings and tune 8309
Xie bolts Caution Install two bearing surfaces are large holes at both ends against the adjusting bolt face, pressing screw Qi overall installed with two M42 × 2 nuts back tight, tight back Note that two 8309 bearing clearance. Turn the adjusting bolt by hand to move, when you can feel the flexible rotation.