granulator first boot method

1, the boot, first warming of about forty to fifty minutes. The temperature rose to pull the motor by hand until the belt freely; continuous rotation at work pulling eight to ten times.  Oil machine  to heat up about ten minutes, and then boot, but continue heating, because the normal production requires continuous supplement the heat;
Depending on the nature of the plastic regulate different temperatures.
2, granulating machine work, the machine temperature to maintain stability, not fluctuated. Bleed hole near  oil expeller  area temperature should be maintained until about 200 ℃ (refer to C material, material B).
3, the feed should be uniform, can not appear shortage phenomenon. Loom eat feed speed and feed rate to tie properly. Otherwise it will affect grain quality and yield.
4, shut down the host to completely cut off the power. Nose plugs (with wrench part) must come off. Subject to a separate warm-up before the next use.