Timber mill operating skills

1, straw grinder should be fixed on the ground, can be fixed with cement.
2, the timber mill in the work carried out before the machine before starting the test machine is a simple rotation of the spindle bearings to see whether the normal operation, the gap between the components pre-installation check whether the firm and check the foundation Pellet mill, as installed on the basic stereotypes, reinstall the timber mill, then more waste of time, the material is a waste;
3, shredders and motor to be mounted on the machine base is made with angle.
4, wood flour machine starts operating timber mill to the attention placed on your machine and debris, lumber mill test machine to see if the reverse, put less material fineness finished processing them to see whether the target customers to buy lumber mill after returning home in time to put the test machine installed when you try to wait for the previous one timber full of wood and then put into the feed inlet second block,Briquette machine to avoid situations card machine.
5, straw grinder feeding should be uniform, if found to have noises, the bearing and the body temperature is too high or outward spray material, etc., should immediately stop inspection, troubleshooting.
6, the timber mill startup and shutdown circuit checks before they are done in order to avoid leakage from happening. The length of timber must be moderate, not too long, 30 cm below the top, not too thick. Spout inlet at four weeks and spacious as possible and avoid the occurrence of a number of accidents.
7, after 300 hours of operation straw grinder should be cleaned bearings,
machine for pellets; installed oil to fill the gap bearing 1/3 as well, to a maximum of 1/2. Downtime, you should remove the belt.
8, straw shredder before the shutdown stops feeding, stand inside the material exclusion clean, then cut off the power shutdown. After the shutdown should be cleaned and maintenance.
9, straw grinder former staff working materials should be carefully checked to prevent the metal, stones and other hard objects into the crushing chamber to cause the accident.
10, straw shredders do not often replace the pulley, to prevent excessively high or low speed