The use of peanut oil press

     Use oil processing , you should first prepare all assistive devices and containers, check and adjust belt tightness. Then start the motor, the machine

Empty 15min running around, checking pressing screw shaft speed. Average speed should be around in

33dmin. Idling gear box to the attention of meshing gears and sound

Sound is normal, each bearing parts and the motor is normal. Oil press idling, the motor current

should be about 3A. If current is too high, you should stop immediately seized

Investigation, adjustment and then boot.
Load is normal, around 50kg ready rapeseed or soy, ready hopper. Note: when you start squeezing the

feed can not be too fast, otherwise the pressing chamber pressure

Sudden increase in the Pellet mill screw shaft can not rotate, causing blockage pressing chamber, and

even squeeze cage rupture, a major accident. Thus begins the compression, the feed should be

uniform slow

Put into the hopper, the oil press for running-in. So repeatedly, sustained more than 3 ~ 4h, the

oil press temperature gradually increased, and even take smoke (which is

Normal phenomenon). Start squeezing when pressing chamber temperature low, slow twist, withered

section stud on the handle to increase the thickness of the cake, while increasing the moisture

squeezed into billet

Until the pressing chamber temperature. Rose to about 90 ℃, oil press after the normal operation,

the thickness of the cake can be adjusted to 1.5 ~ 2.5mm, and tighten the fastening nut.
During operation should always check the oil press cake out of the situation and control the

moisture billet is neither too high nor too low. Normally the cake should be flaky, by pressing

Axis side smooth, the other side has a lot of hair pattern. If the cake loose weakness, or the cake

shapeless, darker color, hand pinch Serve fragments, indicating billet

Add water too; such as the cake soft, National Cheng Kung University flake, or increase the oil

bubble, then said Minga too much water. Under normal circumstances, no residue or between the rows

round rarely

Slag, slag in the row at the bar, such as the description of the slag was fine flake more water,

the powder residue indicates less water. In addition, changes in position to see the oil squeezed

out of water

Is appropriate, when squeezed into the water is too high or too low, the oil positions are

backward.